Dolphin, the GameCube and Wii emulator - Forums

New Super Mario Bros and Skyward Sword are known to constantly send a lot of commands to the BT module, so your adapter probably isn't being able to handle them fast enough...

(11-03-2016, 12:53 PM)Jhonn Wrote: [ -> ]New Super Mario Bros and Skyward Sword are known to constantly send a lot of commands to the BT module, so your adapter probably isn't being able to handle them fast enough...

Thanks for the info.  All the more reason then to find another adapter.

(11-03-2016, 07:19 AM)leolam Wrote: [ -> ]It's not needed anymore in the latest version of the PR. Just set the VID and PID and that's enough to skip the check.

Where can i get the latest version?

(11-03-2016, 06:02 PM)Forgottenkey Wrote: [ -> ]Where can i get the latest version?

https://dolphin-emu.org/download/

(11-03-2016, 11:40 PM)ExtremeDude2 Wrote: [ -> ]https://dolphin-emu.org/download/

No. They're asking for the latest version of a PR.

The link is the same as before, https://dl.dolphin-emu.org/prs/pr-4385-d...est-x64.7z

Did some testing with my generic bluetooth dongle, and after removing those two files, pairings with my single wiimote stayed, other than with skyward sword, which requires some fiddling to get working properly. After a successful connection, though, skyward sword stayed paired during the game for the couple minutes I played.

Also, that PR has been merged, so the new link is https://dolphin-emu.org/download/dev/234...0308b82ef/, or just https://dolphin-emu.org/download/

I've updated the wiki article to suggest deleting the SYSCONF + btdinf.bak if pairings don't work, yet the adapter is supposed to work. May happen when using an older build which didn't support BT passthrough.

Skyward Sword only spams commands before you get in game; there's no issue after you get past the "connect your remote, Nunchuk and Motion Plus" screen.

Hm... after testing my bluetooth dongle with a third party wiimote, it doesn't pair, while an original nintendo wiimote pairs fine.

There's no BT stack limitation this time, so unless you can get the 3rd party Wiimote working with a Wii, I'd say it's a remote issue.

I currently have my Bluetooth adapter setup with the driver setup but it doesn't seem to sync up with my Wiimote. It's a official Wiimote RVL-003 and it seems to work fine in emulated mode. I click "Sync" while in game and it says it's scanning and nothing happens. I've tried hitting hitting the sync button once, holding it and hitting other buttons but it just doesn't respond. I've also tried another official Wiimote. I did have to put the USB ID in the ini file also. Any ideas?
VID = 6655
PID = 569

Adapter:
BCM20702A0
19FF 0239