• Login
  • Register
  • Dolphin Forums
  • Home
  • FAQ
  • Download
  • Wiki
  • Code


Dolphin, the GameCube and Wii emulator - Forums › Dolphin Emulator Discussion and Support › Controllers v
« Previous 1 ... 129 130 131 132 133 ... 316 Next »

Instructions to use Wii U adapter Native Support not working
View New Posts | View Today's Posts

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Instructions to use Wii U adapter Native Support not working
08-31-2015, 04:18 PM
#1
DOL-003
Unregistered
 
Hello, I've been reading this page

https://wiki.dolphin-emu.org/index.php?title=How_to_use_the_Official_GameCube_Controller_Adapter_for_Wii_U_in_Dolphin

and successfully installed the driver with Zadig as it said to do, but in Dolphin 4.0, I can't do what it says to do next:

"With any necessary installation complete, run Dolphin, and check "Direct Connect" under GameCube Adapter in the Controller Settings. Set GameCube ports to "Standard Controller" corresponding to each port on the adapter that is plugged in with the actual GameCube controller. The setup for the adapter is now completed. To test, simply start a game that uses GameCube controllers."

There is no 'direct connect' under controller settings, probably because there is no controller settings. What is up with that?

If I go into config>gamecube tab>device settings partition, it shows memory cards and controller ports 1-4 and dropdown menus to choose controller, but no direct connect! Huh

Help Confused Sad
Reply
08-31-2015, 05:03 PM
#2
DOL-003
Unregistered
 
Nvm, I figured it out. Though now I'm worried I can't run dolphin at all on my computer. yay.
Reply
« Next Oldest | Next Newest »


  • View a Printable Version
  • Subscribe to this thread
Forum Jump:


Users browsing this thread: 1 Guest(s)



Powered By MyBB | Theme by Fragma

Linear Mode
Threaded Mode