I have a dolphin bar that I want to install in my arcade cab.
There are 2 possibilities for positions, either the bottom which would be on the control panel but it is not directly above the monitor, about 10 inches down so when I try to play a game the precision is very bad.
The top could be a possibility but the way I designed my arcade cab it would look ugly and would still be about 6 inches under the monitor so once again I lose precision.
Is there a way to add an offset to the positionning of the bar somewhere in the software?
Thank you.
There are 2 possibilities for positions, either the bottom which would be on the control panel but it is not directly above the monitor, about 10 inches down so when I try to play a game the precision is very bad.
The top could be a possibility but the way I designed my arcade cab it would look ugly and would still be about 6 inches under the monitor so once again I lose precision.
Is there a way to add an offset to the positionning of the bar somewhere in the software?
Thank you.