Help calibrating my xBox controller's triggers

Help calibrating my xBox controller's triggers - Printable Version

+- Dolphin, the GameCube and Wii emulator - Forums (https://forums.dolphin-emu.org)
+-- Forum: Dolphin Emulator Discussion and Support (https://forums.dolphin-emu.org/Forum-dolphin-emulator-discussion-and-support)
+--- Forum: Controllers (https://forums.dolphin-emu.org/Forum-controllers)
+--- Thread: Help calibrating my xBox controller's triggers (/Thread-help-calibrating-my-xbox-controller-s-triggers)

Help calibrating my xBox controller's triggers - jakemnz - 12-22-2013

I know there have been several threads asking for help with this problem and I've seen a few, but none helped. My problem is that when I go to lightly press my L or R triggers, the emulator thinks I'm not pressing at all. Then, when I press a little harder, it thinks I'm pressing all the way. I believe this has something to do with the threshold and I've tried adjusting that but to no avail. If someone could help me fix this or provide a link to a thread that would help, I would really appreciate it. Thanks!

RE: Help calibrating my xBox controller's triggers - Billiard26 - 12-22-2013

Show your config.
You will most likely want your right trigger mapped to both R and R-Analog. (and the same for the left) (searching the forum would probably reveal this)

RE: Help calibrating my xBox controller's triggers - jakemnz - 12-23-2013

(12-22-2013, 10:27 PM)Billiard26 Wrote: Show your config.
You will most likely want your right trigger mapped to both R and R-Analog. (and the same for the left) (searching the forum would probably reveal this)

I searched and I did what they all said but nothing really worked. They all just said to lower the threshold.

[Image: hidK72y.png?1]

RE: Help calibrating my xBox controller's triggers - Soopah - 12-23-2013

actually you didn't set L-Analog and R-Analog so you have just L and R like a button.

RE: Help calibrating my xBox controller's triggers - jakemnz - 12-23-2013

(12-23-2013, 01:11 AM)Soopah Wrote: actually you didn't set L-Analog and R-Analog so you have just L and R like a button.

I went off of a picture of a GameCube controller when I configured this. I didn't see anything labeled as L or R analog. I just used the back triggers. What am I supposed to set as the analog?

RE: Help calibrating my xBox controller's triggers - jakemnz - 12-23-2013

I found the problem. I didn't know that the analog was also supposed to be set up with the triggers. This thread can be locked or deleted.