+- Dolphin, the GameCube and Wii emulator - Forums (https://forums.dolphin-emu.org)
+-- Forum: Dolphin Emulator Discussion and Support (https://forums.dolphin-emu.org/Forum-dolphin-emulator-discussion-and-support)
+--- Forum: Support (https://forums.dolphin-emu.org/Forum-support)
+--- Thread: Multiple Gamecube controllers (/Thread-multiple-gamecube-controllers--15315)
Multiple Gamecube controllers - kingbob337 - 02-22-2011
Hey I mapped xbox controllers to gamecube controller 1, 2, 3, and 4. The emulator recognizes them just fine. I can set up and map each one just fine; however, when I go into the game (Smash bros Brawl) it only reads the first controller, GCpad 1. The game itself is not recognizing the other gamecube controllers being connected.
Before someone tries to troll me, yes I read 10+ different post last night about using xbox360 controllers and none of them deal with this issue of multiple controllers.
I used 7128 x64 if that makes a difference.
RE: Multiple Gamecube controllers - inteGReddy - 02-22-2011
well... if you looked around in the menus enough you'd see that under the gamecube setting, there are dropdowns for each controller port. i would recommend setting all four of them to have a gamecube controller connected. also, make sure you have all four wiimotes set to none in the wiimote settings page.