{GC] Burnout 2 - Point of Impact - GB4P51 - [PAL] - Printable Version +- Dolphin, the GameCube and Wii emulator - Forums (https://forums.dolphin-emu.org) +-- Forum: Dolphin Site (https://forums.dolphin-emu.org/Forum-dolphin-site) +--- Forum: Old Game Discussion (Archive) (https://forums.dolphin-emu.org/Forum-old-game-discussion-archive) +--- Thread: {GC] Burnout 2 - Point of Impact - GB4P51 - [PAL] (/Thread-gc-burnout-2-point-of-impact-gb4p51-pal)

{GC] Burnout 2 - Point of Impact - GB4P51 - [PAL] - Chriztr - 01-01-2011 Hi everybody. First I want to tell you how amazing this emulator is. And I want to thank you all for your hard efforts in this project. Recently I've been playing Burnout 2 and got stuck with a error-messages that wont stop showing up. It happens at the same place in the game, and I've tried various of settings whitout any luck. I'm using mamarios latest build; R6706 x64 Here's a picutre of the place and the error-message: Uploaded with ImageShack.us RE: {GC] Burnout 2 - Point of Impact - GB4P51 - [PAL] - Chriztr - 01-01-2011 A simple solution was to disable PanicHandler. RE: {GC] Burnout 2 - Point of Impact - GB4P51 - [PAL] - Starscream - 01-01-2011 I've played through this game with r4500 and back then the same thing happened. What I ended up doing was just pressing "yes" over and over again and while pressing yes, the game would continue on but very slowly. I did this till I passed that one very specific area of the map and then the game continued on normally. Unfortunately, the same thing happened on the next lap but eventually I was able to finish. It seems to only be that one small section of that level that causes this. I don't remember if the panic handler option fixed this back then. RE: {GC] Burnout 2 - Point of Impact - GB4P51 - [PAL] - Chriztr - 01-02-2011 Well, it did fix it this time. But I noticed something else. If you're using the Dx9 plugin at one of the leves the game will freze but music will continue playing. Changing from dx9 to OpelGL seems to get past this freze.