hi, i don't know what config i should use to fully use my pc, i have an i5 3470, gtx 660 ti 8 gb ram 1500 gb hard drive and runing on windows 7, ty
OpenGL was recently set as default in development builds
And don´t refer at all to D3D11, just call it D3D.
(01-16-2014, 08:19 AM)ExtremeDude2 Wrote: [ -> ]And why not?
Since DX9 has been removed, it´s no case to still call it DX11 ´cause it´s the only D3D backend remaining. It would be more simple to just call it D3D (people should already know that it´s DX11). Also it appears D3D onlý on the emulator configs.
I still think d3d11 is more proper. Either one is valid though.
Why not just call it the DICKS backend? DICKS9 and DICKS11 are much easier to say (and type, in most cases) than DX9 or D3D11.
So....what you're saying is......you prefer DICKS?
Tried to make this into a working acronym. Can't figure out what to use the K for.
K always stands for overclockable. Have you learned nothing?
Dolphin is currently kool shit. I can come up with a proper acronym if given time. Used to play this game with family all the time when on trips or bored, state a random word and make an acronym for that word.
To answer OP, with latest builds use D3D11 or OGL, if you can't use D3D but can use OGL, use that instead. If you can run neither maybe v4.0 still has D3D9, if not then v3.5 however you'll likely forfeit forum support if you use older unsupported builds. With proper hardware OGL is faster in recent builds than D3D11 however I don't think your hardware is adequate enough to benefit from speedups with OGL.