Dolphin, the GameCube and Wii emulator - Forums

Hello!

So i downloaded dolphin, games works fine but i cant bring my 360 controller to work in game.
I configured it properly in the menu, its also responding well (red dots moving, red squares moving), i saved it, but when i enter the game, no respond at all...

This is what i did:

Options --->Gamecube pad setting--->xinput/0/gamepad---> configured everything & checked that everything workes properly--->save--->OK

I enter the game and nothing...

What is the problem?

What game?

(07-31-2012, 02:58 AM)Garteal Wrote: [ -> ]What game?

New Super Mario Bros!

No wonder. You should set up an Emulated Wiimote, not a GC controller.

(07-31-2012, 03:16 AM)Garteal Wrote: [ -> ]No wonder. You should set up an Emulated Wiimote, not a GC controller.

Yes its working, thank you very much.
Can you give me an example how to configure the buttons for this setting?
I used youtube to configure the controller but it was for the gamecube setting, for the wiimote its very different and i dont know what to do with most of the buttons...
For example when Mario flying in game i need to move the controller for him to be able to fly, and i dont know how should i configure it.

It's very straight-forward and easy to set it up.
For NSMB, you only have a Wiimote, which makes it even easier.

First, setup the run, jump and the menu buttons.
To move, set up the D-Pad on the far-right to whatever you use to manoeuver your character.
You can setup the 'shake' of the Wiimote in the shake area.
Just put it on a button, and whenever you press it, you'll emulate a Wiimote shake.

You'll probably need to tilt the Wiimote at some point.
Simply go to the tilt area, and setup the left and right buttons of it.
You might want to put that on the right analog stick. (Or whatever you're comfortable with)

I did it!
Thank you very much this is for you

(07-31-2012, 02:53 AM)tan223 Wrote: [ -> ]Hello!

So i downloaded dolphin, games works fine but i cant bring my 360 controller to work in game.
I configured it properly in the menu, its also responding well (red dots moving, red squares moving), i saved it, but when i enter the game, no respond at all...

This is what i did:

Options --->Gamecube pad setting--->xinput/0/gamepad---> configured everything & checked that everything workes properly--->save--->OK

I enter the game and nothing...

What is the problem?

I have the same problem but for the Gcube games. I don´t know what to do. I have tried all that i can think of.

Make sure port 1 is set to standard controller under the 'config'-->'gamecube' tab

Here is a pic of how my config screen looks. See if you can see what is wrong.

Oh. And when i load a savestate from a game it seems like the cursor is moving down and left without me doing anything. Dont know if that might help.

I have the dead zone so that when im not touching the sticks they are inside the gray areas.