Hi guys. I am using XBoxcontrol. Got up to level with a stingray and stuck.
Got a message that attached "To turn left, twist, left from that starting position". Pressed all possible buttons and nothing. Any help?
What can I do?
Real wiimote + nunchuck require
You can also try press "shake" + "roll left" button but not sure it will work
ok so what you gotta do...go to the wimmote plugin..not the new wiimote plugin...and set up the roll and pictch and all that with the camera button....and change a couple of other things but all in all it does work without wiimote...but all you gotta do to get back to original settings is switch the wiimote plugins again..new wiimote plugin doesnt support roll and pitch from what ive seen...i had the same problem but it does work...play around with is and it will work.
The new wiimote plugin doesn't yet support emulated IR camera tilting. (which is probably what this part of the game is looking for)
Emulated accelerometer tilting should work fine.
(08-15-2010, 09:21 AM)sqa Wrote: [ -> ]Hi guys. I am using XBoxcontrol. Got up to level with a stingray and stuck.
Got a message that attached "To turn left, twist, left from that starting position". Pressed all possible buttons and nothing. Any help?
What can I do?
Heres my configuration...everything tht i didnt emulate for the wiimote is at a Num 0
so thts what i didnt use for all of tht
but anyways...pay attention to what the analog says and stuff like tht in the window
OK, I am trying to get this position (Attached) with the following controlpad settings (attached).
And I cannot continue untill I press something that corresponds with requested action.
I am sure that lots of you passed it already, how did you do that?
see when it says turn left and twist...turn left and twist...i checkmark will appear but keep holding it until it says good job
also top right corner......says tilt and swing...change both analogs to analog two so that the camera will now do both tilt and swings...tht way you have it mapped out no matter what
gl it should work...
hey and when you get a little farther tell me how you passed the ball galaxy with the rolling ball you have to control
best config i found goes as follows....analogs are both already used
A- lower L button
B-lower R button
shakefor both- top R button
crouch button- top L button
and now you have room to place two sets of directional pads and the buttons left right up down and the D pad
also plus sign is the select button and home is start button.
hope it helps
Thanks man, I have passed that stingray race.
Yap now the ball. Trying to find out the way, haha.
"...hold straight up" driving me crazy.
with the analog being emulated as two diff movements...use the camera and when it says point up go up with the wiimote...tht ones really hard btw lol i just got it today
all you have to do is hold it up and left and right and jump and it works just fine
(08-18-2010, 05:35 AM)sqa Wrote: [ -> ]Thanks man, I have passed that stingray race.
Yap now the ball. Trying to find out the way, haha.
"...hold straight up" driving me crazy.
Why not check the "Upright Wiimote" box to emulate an... upright wiimote. :p