zelda wind waker runs slow

[junior600]

hello everyone!how are you?I have a problem with the last revision of dolphin...zelda wind waker run slow. I try to configure dolphin but the fps are 20 between 25.If is possible,can you post your dolphin with your config for wind waker?my specs are:
intel dual core e5200 a 3.75 ghz
2 gb ram ddr2 800 mhz
gts 250 (geforce 9800 gtx+)
is my config the problem?
sorry for my bad english xd

[Jefferson]

http://forums.dolphin-emu.org/thread-40.html
If the new version runs it slow. Try the latest version that worked fine.
Enable: Dual Core, Idle Skipping, HLE the IPL, JIT Recompiler, Optimize Quantiziers, DSP on thread.
Use DX9: Enable EFB to copy: to texture, 4:3 Aspect radio.
DSP: Only active the 1rst option.
Frameskipping set to 1. Watchdog: 30. Framelimit: off
Mm.....Your machine is good.

[Unknownforce]

(12-15-2009, 05:58 AM)junior600 Wrote: hello everyone!how are you?I have a problem with the last revision of dolphin...zelda wind waker run slow. I try to configure dolphin but the fps are 20 between 25.If is possible,can you post your dolphin with your config for wind waker?my specs are:
intel dual core e5200 a 3.75 ghz
2 gb ram ddr2 800 mhz
gts 250 (geforce 9800 gtx+)
is my config the problem?
sorry for my bad english xd

Is this the PAL version of the game? if so, 25fps is full speed. NTSC full speed is 30 fps.

[slimmshady]

What you need to do is switch the graphics plugin to "direct3d9" and then go into "advanced". Next under "EFB Copy", switch from "To RAM" to "To Texture" and that should solve the issue for you. Oh and also enable "disable Fog" from the same "advanced".