Zelda Skyward Sword - Real Controls

[pinktiger]

I've been reading through the thread but I couldn't find anything specific.

I got a new Wii Motion Plus Inside (built-in & TR) controller. I finally got it to work with Dolphin 3.0-587 by using the Toshiba Bluetooth Stack.

I got most of the games to work except the ones that require "Motion-Plus" like Zelda Skyward Sword & Red Steel 2. It doesn't seem that Dolphin recognize my built-in Motion Plus controller.

Is there a way to get Dolphin to recognize the controller? A real Nintendo controller. I'm not interested in emulated controller etc.

[GizZm0]

hello pinktiger!

sometimes i have the same problem. it recognizes my wiimote but not the motion plus inside.
but when i restart the controller and connect it again to dolphin it works. donno why. the motion plus extra adapter works better with dolphin

[Squallboogie01]

Just got my Wiimote +, official from Nintendo RVL-CNT-01-TR, code inside the remote LMB-RVL-WR/Z-C4, and tried to link it up to my pc and it densest seem to work. I have the AZiO Bluetooth dongle with Microsoft Bluetooth Stack. Sometimes its able to recognize the controller, install it, but in Dolphin it says its there, but when im in Zelda the controller doesn't work. The lights flash, and some times they wont even turn on. But in Dolphin it shows it has 1 real wiimote connected. No 1 player light. I have also just tried getting the Toshiba Stack to see if that works. Dolphin comes up with an error message stating that my bluetooth device isn't supported with that, only Microsoft Bluetooth Stack. Any help would be greatly appreciated, and I'm sure I missed some solution buried somewhere in these forums.
One more thing, I'm able to link up my original Wiimote with no plus in it and it works, just not for this game.

Edit: Did lots of searching, and got it to work thanks to warnimon in this thread,
http://forums.dolphin-emu.org/showthread.php?tid=19948&page=18&highlight=LMB-RVL-WR%2FZ-C4
Following these steps
1. Click to pair a new device, follow the instructions and press the 1 and 2 button on the TR remote enter discovery mode. The remote should now be listed as paired device.
2. Right click the TR and select connect, a dialog pops up.
3. Press the 1 and 2 button on the remote and leds start to blink, when the leds stop click OK on the dialog.
4. The remote should be connected now, but no leds. Check this by pressing the A button, no leds should blink. If leds start to blink restart from 2.
5. Open Dolphin (first close if it was still open), make sure it has the code changes stated above, hit the Wiimote button and press refresh.
6. One led on the TR should light up indicating it's number and the TR rumbles. If not hit refresh again or restart from 2.
The TR should now be fully functional.

[lusti0]

Hi i have a problem.I have this message "connect a nunchuk to the wii" only wiht zelda.Other games working.What is my fail?Thx

Have a xbox360 controller

[ExtremeDude2]

(05-09-2012, 06:28 AM)lusti0 Wrote: Hi i have a problem.I have this message "connect a nunchuk to the wii" only wiht zelda.Other games working.What is my fail?Thx

Have a xbox360 controller

Don't post the same thing 3 times

[lusti0]

(05-09-2012, 07:55 AM)ExtremeDude2 Wrote:

(05-09-2012, 06:28 AM)lusti0 Wrote: Hi i have a problem.I have this message "connect a nunchuk to the wii" only wiht zelda.Other games working.What is my fail?Thx

Have a xbox360 controller

Don't post the same thing 3 times

Can you help me?

[theman88]

Ok so I seem to be encountering some issues. First off I'm using an actual wii remote with an actual wii motion plus with an actual nunchuck. The first issue I'm getting is any time i want to start up the game I go through the hole "Please connect the nunchuck blah blah blah" I seem to get by it after ten minutes of plugging and unplugging it, is there any way to speed this up? my second issue is that after I get passed that screen I then must point the pointer at the screen and simply press "A". Well for whatever reason it either won't see the pointer, or I have to hold the remote sideways? as if sideways is strait. ( what i mean by sideways is laying the remote down on a flat surface and rotating it a complete 90 degrees to the right. like a hand on a clock)
My third and final issue which is really where my problem lies is, when I'm in game after a while dolphin "or the game" gets the wii remotes' relation to space all mixed up. soon link will start holding his sword near his back right all though I'm holding the wii remote center. It does seem to correct if I sit at a 90 degree angle to the right...but I'd rather not if you guys have any tips or suggestions PLEASE POST THEM!.

[theman88]

Bump?

[Yevgeniy]

I am currently using the 360 controller setup and it works really good. Thanks.

[Zero9X]

Hi,

Anyone have a recommendation for a bluetooth dongle to use with the official Zelda wiimote & motion plus built in. So many choices about!