Hello again. I've properly setup everything just fine for my Xbox One controllers replacement of the Gamecube controller, however, my camera keeps spinning upwards. How do I solve this? I've tried adjusting deadzone and radius already.
Xbox One controller spiraling upward as GameCube replacement
|
01-10-2018, 05:20 PM
(01-10-2018, 04:57 PM)jsbradford97 Wrote: Hello again. I've properly setup everything just fine for my Xbox One controllers replacement of the Gamecube controller, however, my camera keeps spinning upwards. How do I solve this? I've tried adjusting deadzone and radius already. Try calibrating the Gamepad in windows..... that usually solves a lot of issues. Search for "Set up USB game controllers" in windows or something like that.
Check my profile for up to date specs.
01-10-2018, 05:24 PM
Does this happen in the latest dev build for Dolphin?
Also, did you check and see if you're running the latest firmware on your Xbox One Controller? (Cause you either need to be on the latest, or an older one for it to work right, can't remember which it is 01-10-2018, 05:43 PM
01-10-2018, 05:44 PM
(01-10-2018, 05:24 PM)KHg8m3r Wrote: Does this happen in the latest dev build for Dolphin? How does one do this? 01-10-2018, 05:47 PM
In the Windows Search bar, search for "Set up USB game controllers" Then click on the controller, and its either advanced or properties
Its an app by Microsoft, you'll need to google for it. 01-10-2018, 05:54 PM
(01-10-2018, 05:47 PM)KHg8m3r Wrote: In the Windows Search bar, search for "Set up USB game controllers" Then click on the controller, and its either advanced or properties Thanks for that, but which app? As for the calibration, I had no idea what the "Z axis" was and I couldn't move my right analog all the way to the bottom right for some reason. 01-10-2018, 08:40 PM
01-10-2018, 11:36 PM
(01-10-2018, 05:54 PM)jsbradford97 Wrote: Thanks for that, but which app? As for the calibration, I had no idea what the "Z axis" was and I couldn't move my right analog all the way to the bottom right for some reason. Z-axis are your analog shoulder triggers, the issue with your right analog: there is your problem. Also to me it seems that you have only tested the calibration, but not actually calibrated the controller. Short explanation how to do it: https://www.maketecheasier.com/calibrate...windows10/ This also works with Windows 7
Check my profile for up to date specs.
01-11-2018, 01:23 PM
|
« Next Oldest | Next Newest »
|
Users browsing this thread: 1 Guest(s)