• Login
  • Register
  • Dolphin Forums
  • Home
  • FAQ
  • Download
  • Wiki
  • Code


Dolphin, the GameCube and Wii emulator - Forums › Dolphin Emulator Discussion and Support › Controllers v
« Previous 1 ... 59 60 61 62 63 ... 319 Next »

Xbox One controller - L and R can't be used simultaneously
View New Posts | View Today's Posts

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Xbox One controller - L and R can't be used simultaneously
08-26-2018, 10:02 AM
#1
Paulando
Unregistered
 
Hello all!

I've setup my Xbox One controller with Dolphin and it's working brilliantly - both triggers are mapped to L, R, L-analog and R-analog, so I get full analogue triggers. They cannot be used at the same time though - when I hold one, then hold the other, it cancels out the first one.

A few suggestions on here said to use XINPUT rather than DINPUT, but I am using XINPUT. The L and R triggers are both seen as the same axis: Z- and Z+, which is where I'm thinking the problem lies.

Is there any way of fixing this? Undecided

The emulator is stunning, by the way. Runs perfectly on my system, looks and sounds just like it does on the real console.
Reply
08-26-2018, 11:19 AM
#2
ExtremeDude2 Offline
Gotta post fast
*******
Posts: 9,306
Threads: 273
Joined: Dec 2010
Can you see the both bars moving below the button config?
Check out my videos (dead)
[Image: sig-22354.png]
Website Find
Reply
08-26-2018, 12:10 PM
#3
mbc07 Offline
Wiki Caretaker
*******
Content Creators (Moderators)
Posts: 3,562
Threads: 47
Joined: Dec 2010
Are you really sure you're mapping them through XInput? That's a known issue (not just with Dolphin) that happens with Xbox controllers if you map them through DInput...
Avell A70 MOB: Core i7-11800H, GeForce RTX 3060, 16 GB DDR4-3200, Windows 11 (Insider Preview)
ASRock Z97M OC Formula: Pentium G3258, GeForce GT 440, 16 GB DDR3-1600, Windows 10 (22H2)
Find
Reply
08-26-2018, 08:41 PM
#4
Paulando
Unregistered
 
Ahh! Totally my mistake. It was listed as 'XINPUT compatible device', but was actually using dinput. After disabling and re-enabling the controller I managed to get xinput to show up separately. Thanks!
Reply
« Next Oldest | Next Newest »


  • View a Printable Version
  • Subscribe to this thread
Forum Jump:


Users browsing this thread: 1 Guest(s)



Powered By MyBB | Theme by Fragma

Linear Mode
Threaded Mode