WML-C43 / J27H002 USB Adapter

zero0 · (This post was last modified: 08-08-2019, 11:22 AM by zero0.)

A little too late but Just learning to use KiCAD and started on this project if anyone is interested in the files. Need to measure again before manufacturing. I will sell them for $10 fully assembled; all you need is connect your Bluetooth module.

Silent Hell · 08-22-2019, 02:08 PM #2

This would actually be pretty dope. I tried my hand at soldering and it looked like hot garbage. I'll try again later, but this would probably be a better alternative for my unsteady hands.

**AnyOldName3** · 08-23-2019, 03:02 AM #3

And it's got the plug on and everything? I imagine this is going to be pretty useful for a lot of people.

themanuel · 08-31-2019, 01:54 AM #4

I already soldered 2 different module. Because I was on a hurry and lacked vision, I reused the reg and cable from my first one on the second one, instead of doing two full modded modules. I've never been too satisfied with the way my soldering job ended up, and I found it insanely difficult.

At any rate, I would jump on this thing for a reasonable price and buy a third module, since they are so cheap. However, for this to be helpful it should not require soldering into small flat contact pads, which is what makes the job difficult.