Wii Sensor Bar - USB POWER Fix (6 LEDS)

08-21-2012, 01:14 AM **#11**

I'll post a picture of my sensor bar later, I rigged it together for $1 Big Grin

Basically just have 6 LED's with 1.6V forward voltage in parallel with 5V usb power and 20 ohm load resistor.

Maxo · 08-21-2012, 11:33 AM **#12**

(08-19-2012, 02:07 PM)ulao Wrote: Do you men the ultra bar? The big black one... If so no, that is a 7 volt device.

The ultra Wii sensor bar yeah, i need someone to give me a hand with it since it eats 4 batteries

**ulao** · (This post was last modified: 08-22-2012, 02:05 AM by ulao.)

You are not going to make that work well with out 6 ( I was wrong saying 7 ) volts. A usb supplement will not work. This bar was designed for the simple fact every one wanted a wii brand wireless. Your by far better off using a cheep on on ebay that only uses 3 batteries. I find mine works really well with the power saver set to 1hr and using rechargeables.

02-22-2016, 05:39 AM **#14**

Sorry to revive an old thread, but can you upload the pics again or fix them?

They're broken. D: