Wii remote doesn't connect

[joku]

My Wii remote was working correctly. Then i installed different bluetooth drivers because my other wii remote wasn't working, but installed the default windows drivers back.

But now my working wii remote won't connect. When i go to dolphin controller settings and press 1+2 on the remote and then refresh or put on continuous scanning, windows says that its setting up the controller and then says its ready to use, but the wii remotes leds keep blinking and then turn off. The remote connects just fine to my real wii and my laptop tho.

I've been testing different things for hours now but can't figure out the problem. I loved playing on it so much that i might just reinstall windows completelly if i don't find a solution. I'll test everything if you have any suggestions. Thanks!

[WiiPlusFreak]

What I usually do is on Windows 10, I go to control panel > Devices and printers > Add a device and then sync there.

If you're using a Mayflash Dolphin Bar, simultaneously press 1 + 2 and press the sync button on top of the Dolphin Sensor bar.

[ExtremeDude2]

What drivers did you install? Have you tried bluetooth passthrough?

https://wiki.dolphin-emu.org/index.php?title=Bluetooth_Passthrough

[joku]

I installed toshiba bluetooth stack drivers or something like that. And i haven't tested bluetooth passtrough. what's that?

---

Oh, that. I tested it but it said it didn't find a bluetooth adapter or something

---

It does the same thing when i try to connect from there. Says it connected but keeps blinking and then the leds just shut off.

[ExtremeDude2]

(05-31-2020, 04:12 AM)joku Wrote: I installed toshiba bluetooth stack drivers or something like that.

This is probably not a good idea, it's best to use the default windows stack.