[Wii] Dragon Quest Swords: The Masked Queen and the Tower of Mirrors

**LordVador** · (This post was last modified: 11-14-2012, 02:44 AM by LordVador.)

Wiki Page - Dragon Quest Swords: The Masked Queen and the Tower of Mirrors - [edit]

Previous discussion here http://forums.dolphin-emu.org/Thread-wii-dragon-quest-swords-pal--8018

haddockd · 07-10-2013, 10:14 AM #2

Anyone know if the new AX-HLE applies to this game? I get small slow downs in areas when I use LLE and using HLE would help, but not if it causes crashes or the like.

**ExtremeDude2** · 07-10-2013, 11:31 AM #3

I don't know why you'd think it would cause crashes, but yes it should apply to this game I think

haddockd · 07-10-2013, 12:31 PM #4

I was thinking of games like WW that need LLE to function properly. I didnt see anything on the main page above to indicate it either way. Thanks for your input Smile

06-01-2015, 05:14 PM #5

Hi! First of all, sorry for my english...
I HAVE A PROBLEM: I want to play Dragon Quest Swords with Dolphin 4.0 and it runs just GREAT... but in the early game, actually in the tutorial, the game say i need to raise my sword to the sky. Just push it up. But, no matter how i configure my settings, (mouse and keyboard) the game does not do that... Angry

Im a huge DQ fan, and this is the first DQ game i never played... Please somebody tell me what setting do i have to use to run the game properly... ??? Tongue

I use mouse and keyboard setting. THX!!! Rolleyes

**Link_to_the_past** · (This post was last modified: 06-01-2015, 06:42 PM by Link_to_the_past.)

You need a real wiimote to have a good experience playing this game, it relies too much on motion controls. It is the upright wiimote position that you need to set in the emulated wiimote settings.

04-30-2020, 06:01 PM #7

(06-01-2015, 05:14 PM)Batorr Wrote: Hi! First of all, sorry for my english...
I HAVE A PROBLEM: I want to play Dragon Quest Swords with Dolphin 4.0 and it runs just GREAT... but in the early game, actually in the tutorial, the game say i need to raise my sword to the sky. Just push it up. But, no matter how i configure my settings, (mouse and keyboard) the game does not do that...
Im a huge DQ fan, and this is the first DQ game i never played... Please somebody tell me what setting do i have to use to run the game properly... ???

I use mouse and keyboard setting. THX!!!

My friend found out the following:
In Dolphin, go to "Motion Simulation" and in the "Shake" section put a Mouse button in the "Y" entry.
Dead Zone should be 0.00 %
Intensity should be 10.00 cm
Frequency should be 6.00 Hz