Super Smash Brothers Brawl won't boot

05-10-2012, 06:19 AM #1

Just downloaded and installed Dolphin 3.0-631-dirty. I was able to rip Wind Waker just fine and that works well. Super Smash Brother's Brawl on the other hand will start go to the Wiimote safety menu and once it gets out of that it is just a blank white screen that won't load and I just have to quit.

Ripped it using dual layer and single layer with cleanrip 1.4 to the same white screen.

Also my computer should be able to handle anything it throws at it.

I have an Eyefinity setup (triple monitors), but have tried both single monitor and triple monitor, but same result.

Not sure what is wrong with it. I have done all the recommended options in the dolphin menus but also to avail.

Thanks for any help in advance!

**ExtremeDude2** · 05-10-2012, 06:41 AM #2

Redump ftw?

HawaiianPunch · 05-10-2012, 11:12 AM #3

What's the size of your final .iso?

05-10-2012, 11:37 AM #4

I was able to figure it. The problem was that it was only saving 4GBs (because I set it to rip at max size and that only goes up to 4GB.) So split up the ripping. Thanks for the help anyways!

nintendo_nerd · (This post was last modified: 05-10-2012, 03:01 PM by nintendo_nerd.)

Clean Rip sucks for ripping games. Try using USB Loader GX, it does a very good job, and it doesn't have the DVD drive stopping at 85% error that Clean Rip has.

HawaiianPunch · 05-10-2012, 09:05 PM #6

(05-10-2012, 02:49 PM)nintendo_nerd Wrote: Clean Rip sucks for ripping games. Try using USB Loader GX, it does a very good job, and it doesn't have the DVD drive stopping at 85% error that Clean Rip has.

CleanRip is much smaller and simpler, and doesn't require a cIOS (the main reason I use CleanRip). USB Loader GX is an all-in-one solution, but that's not useful for many people on this board.