Settings

[scummos]

My board has a "Clear CMOS" Jumper. Whenever I screw some bios settings, I can just switch that jumper, wait five seconds, switch it back, and it'll reset to factory defaults. Almost every board should have one.

If not, removing the battery from the board for a few seconds should also reset the bios settings.

Just make sure you don't leave your computer running for more than a few seconds with faulty settings: remember that all damage that can possibly happen is *always* because something gets too hot, which is unlikely to happen if it's only running for three seconds.

Greetings

[qulivaxz]

(02-02-2012, 03:05 AM)scummos Wrote: My board has a "Clear CMOS" Jumper. Whenever I screw some bios settings, I can just switch that jumper, wait five seconds, switch it back, and it'll reset to factory defaults. Almost every board should have one.

If not, removing the battery from the board for a few seconds should also reset the bios settings.

Just make sure you don't leave your computer running for more than a few seconds with faulty settings: remember that all damage that can possibly happen is *always* because something gets too hot, which is unlikely to happen if it's only running for three seconds.

Greetings

i will try it now i was ill until today but thank you

[qulivaxz]

i got one more question i think its the last one:

i want to play zelda skyward sword with my keybord but if i start it it says - "connect the wii motion plus accessory and nunchuck to the wii remote. Next, wait a few moments without touching the control stick."

now the problem is: i already made all configurations for the emulated wii mote and the extension as the nunchuck and it doesn't work..

[admin89]

Same as this ?
Have you tick "motion plus" option yet ?