Sensor Bar from dealextreme

[kuno86]

(07-16-2009, 02:25 AM)che Wrote: Is there a tut for that?

I don't know, but here is my little tutorial how i did it.
Find a 6 volt DC transformator, open the housing, find "+"-wire of the transformator and solder it to the a wire which leads to the batterie-"+"-pole inside of the sensorbar.
Do the same for the "-"-pole and you are good to go.
Make a short test with your camera before you solder it.
For a better look, you can drill a small cable-hole through one side of the housing.