So, I ordered up a dolphinbar and some controllers from amazon.
Dolphinbar installed it's drivers, and has the newest firmware on it already. Changes drivers when put in a different setting (1-4).
The problems started when I was trying to sync. I could get either remote to sync as 1, but neither would sync as 2 it'd just sit there flashing.
Ok, I'll try it with just one I thought. Went into dolphin, switched it to real wiimote, and checked cont scanning. Hit refresh and dolphin froze. Restarted it, and this time the remote vibrated when I hit refresh. But it's still telling me that no bluetooth devices are found and the controller config is greyed out.
I messed with it for a good hour and couldn't get past this point. Any ideas?
Dolphinbar installed it's drivers, and has the newest firmware on it already. Changes drivers when put in a different setting (1-4).
The problems started when I was trying to sync. I could get either remote to sync as 1, but neither would sync as 2 it'd just sit there flashing.
Ok, I'll try it with just one I thought. Went into dolphin, switched it to real wiimote, and checked cont scanning. Hit refresh and dolphin froze. Restarted it, and this time the remote vibrated when I hit refresh. But it's still telling me that no bluetooth devices are found and the controller config is greyed out.
I messed with it for a good hour and couldn't get past this point. Any ideas?