• Login
  • Register
  • Dolphin Forums
  • Home
  • FAQ
  • Download
  • Wiki
  • Code


Dolphin, the GameCube and Wii emulator - Forums › Dolphin Emulator Discussion and Support › Hardware v
« Previous 1 … 31 32 33 34 35 … 189 Next »

Problems with dolphin and dolphinbar recognizing remotes
View New Posts | View Today's Posts

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Threaded Mode
Problems with dolphin and dolphinbar recognizing remotes
08-01-2017, 02:14 AM
#1
hippied9
Unregistered
 
So, I ordered up a dolphinbar and some controllers from amazon.

Dolphinbar installed it's drivers, and has the newest firmware on it already. Changes drivers when put in a different setting (1-4).

The problems started when I was trying to sync. I could get either remote to sync as 1, but neither would sync as 2 it'd just sit there flashing.
Ok, I'll try it with just one I thought. Went into dolphin, switched it to real wiimote, and checked cont scanning. Hit refresh and dolphin froze. Restarted it, and this time the remote vibrated when I hit refresh. But it's still telling me that no bluetooth devices are found and the controller config is greyed out.

I messed with it for a good hour and couldn't get past this point. Any ideas?
Reply
« Next Oldest | Next Newest »


  • View a Printable Version
Forum Jump:


Users browsing this thread: 1 Guest(s)



Powered By MyBB | Theme by Fragma