Here is my current setup for general graphics, the per-game config, and AR codes in use.
When I start Wind Waker and load my current save state (problem persists if I use in-game save slot and proceed to same area [forsaken fortress]) I run the game at about 22-28 fps. However, once I open up the graphics config, the game immediately plays perfectly, at 30 fps without any hitches or dips. This performance persists until restart the game/emulation. This happens without fail, and I cannot seem to figure out why.
While an easily fixed issue, it is a minor annoyance I would like to do away with if that is possible. Thank you in advance for any help offered.
When I start Wind Waker and load my current save state (problem persists if I use in-game save slot and proceed to same area [forsaken fortress]) I run the game at about 22-28 fps. However, once I open up the graphics config, the game immediately plays perfectly, at 30 fps without any hitches or dips. This performance persists until restart the game/emulation. This happens without fail, and I cannot seem to figure out why.
While an easily fixed issue, it is a minor annoyance I would like to do away with if that is possible. Thank you in advance for any help offered.