Hi 
I just finished setting up Dolphin and my Joycons as controller, following this guide.
Now, I tried to play DKCR for a few minutes and it seemed alright.
Then I tried to start a game of TLoZ-SS. It seems like anything related to motion sensors is not working or very messy.
Motions are detected but not at all well enough.
For instance it was almost impossible to set my name at the beginning of the game and I thus left "Link" for convenience.
Now, when I run in game, I cannot roll (run+ shake nunchuk, usually). Nothing happens when I shake my left joycon (aka nunchuk) although, as I mentioned above, motions from both joycons are detected although not well enough. Using the sword later in the game sounds like a no-go...
Is there any setting I should pay attention to that I may have overlooked?
Thank you very much in advance for your help.
Best,
-a-
PS. On a couple of occasions, I had issues with the controllers that went beyond what I report here and when I closed the emulation, I noticed that my joycons were now set as individual controllers (horizontal orientation) in BetterJoy, rather than as a single controller (vertical orientation). I fixed that and restarted the emulation but I wonder what's going on here too. Don't know if this is related...
I just finished setting up Dolphin and my Joycons as controller, following this guide.
Now, I tried to play DKCR for a few minutes and it seemed alright.
Then I tried to start a game of TLoZ-SS. It seems like anything related to motion sensors is not working or very messy.
Motions are detected but not at all well enough.
For instance it was almost impossible to set my name at the beginning of the game and I thus left "Link" for convenience.
Now, when I run in game, I cannot roll (run+ shake nunchuk, usually). Nothing happens when I shake my left joycon (aka nunchuk) although, as I mentioned above, motions from both joycons are detected although not well enough. Using the sword later in the game sounds like a no-go...
Is there any setting I should pay attention to that I may have overlooked?
Thank you very much in advance for your help.
Best,
-a-
PS. On a couple of occasions, I had issues with the controllers that went beyond what I report here and when I closed the emulation, I noticed that my joycons were now set as individual controllers (horizontal orientation) in BetterJoy, rather than as a single controller (vertical orientation). I fixed that and restarted the emulation but I wonder what's going on here too. Don't know if this is related...