Hi all
I've got the excellent Mayflash Wiimote sensor bar and it has been doing a good job so far. However with this new blutooth passthrough mode I'm keen to get this working. However I have followed the guide on the Dolphin Wiki but can't get it to work.
I've used Zadig to replace the drivers, much like what I did with the Mayflash GC Adopter. When I try to load a game I get an error about no blutooth devices found and Dolphin closes.
I've also edited the Config file and replaced the VID and PID, though I'm not sure if I got the conversion from HEX to Decimal correct. The current USB ID is 057E 0306 00 and converting this to Decimal should mean it's 023588963840 correct?
Am I missing something here?
I've got the excellent Mayflash Wiimote sensor bar and it has been doing a good job so far. However with this new blutooth passthrough mode I'm keen to get this working. However I have followed the guide on the Dolphin Wiki but can't get it to work.
I've used Zadig to replace the drivers, much like what I did with the Mayflash GC Adopter. When I try to load a game I get an error about no blutooth devices found and Dolphin closes.
I've also edited the Config file and replaced the VID and PID, though I'm not sure if I got the conversion from HEX to Decimal correct. The current USB ID is 057E 0306 00 and converting this to Decimal should mean it's 023588963840 correct?
Am I missing something here?
Handz Gaming on YouTube: https://www.youtube.com/HandZ_gaming
The Retro Byte (Including Dolphin videos): https://tinyurl.com/TheRetroByte[url=https://www.youtube.com/playlist?list=PLh9SHYt4z-C-43uNJA8kuoYc1txrJPkxh][/url]
The Retro Byte (Including Dolphin videos): https://tinyurl.com/TheRetroByte[url=https://www.youtube.com/playlist?list=PLh9SHYt4z-C-43uNJA8kuoYc1txrJPkxh][/url]