Mayflash Wii U Pro Adapter: No DInput?

[RicoSteves]

So I have been getting very frustrated with this lately. I have bought the Mayflash adapter as well as two Hyperkin Procube controllers. Using XInput, I have been able to get one controller to work. However, you can't use more than one controller on XInput, forcing you to use DInput. However, even though the adapter is switched to DInput and the two controllers show the player's 1 & 2 leds on them, the DInput doesn't show work. Even though two controllers are attached to it, there is only one DInput that shows up (DInput/0/Keyboard) and that doesn't respond to my controller's controls. What am I doing wrong? I am using the most recent version of Dolphin.

[KHg8m3r]

You should install the zdiag drivers and switch the adapter to Wii U mode, then have Dolphin set to real controllers. Read here how: https://dolphin-emu.org/docs/guides/how-use-official-gc-controller-adapter-wii-u/

[RicoSteves]

(04-29-2018, 09:04 AM)KHg8m3r Wrote: You should install the zdiag drivers and switch the adapter to Wii U mode, then have Dolphin set to real controllers. Read here how: https://dolphin-emu.org/docs/guides/how-use-official-gc-controller-adapter-wii-u/

Let me say this again: I am using the Mayflash Wii U Pro Controller Adapter, not the GameCube controller adapter. There is no Wii u mode. Just xinput and dinput modes.

[KHg8m3r]

You got me there. Read your post too fast

Did you check the Mayflash website and make sure you're on the latest firmware?

Does Windows see it as multiple controllers? I think you can check with the Windows controller calibration tool: https://support.xbox.com/en-US/xbox-on-windows/accessories/calibrate-xbox-360-controller-for-windows

Does this happen in 5.0 stable, or 5.0 dev builds?

Does this happen with official Wii U Pro controllers as well as the Hyperkin Procube?

[RicoSteves]

(04-29-2018, 10:46 AM)KHg8m3r Wrote: You got me there. Read your post too fast

Did you check the Mayflash website and make sure you're on the latest firmware?

Does Windows see it as multiple controllers? I think you can check with the Windows controller calibration tool: https://support.xbox.com/en-US/xbox-on-windows/accessories/calibrate-xbox-360-controller-for-windows

Does this happen in 5.0 stable, or 5.0 dev builds?

Does this happen with official Wii U Pro controllers as well as the Hyperkin Procube?

I only own hyperkin controllerw. This happens on latest 5.0 and stable 5.0. Windows sees it as 2 different HID devices.

[RicoSteves]

(04-29-2018, 11:40 AM)RicoSteves Wrote: I only own hyperkin controllerw. This happens on latest 5.0 and stable 5.0. Windows sees it as 2 different HID devices.

Bump

[JMC47]

Have you made sure everything is plugged in before you start Dolphin? Dolphin doesn't have hotplugging on windows.

[RicoSteves]

(05-05-2018, 11:14 AM)JMC47 Wrote: Have you made sure everything is plugged in before you start Dolphin?  Dolphin doesn't have hotplugging on windows.

Yup