HI! So I have browsed the forums hoping to find a solution... but I have not so I am going to ask you guys it.
I recently bought a mayflash thing. Here is what i did
1. Held sync
2. Plugged it in
3. Updated software
4. Press sync on bar and remote
5. The wii remote was controlling my mouse working just fine
6. Went into dolphin and went into wii controllers
7. Set remote one to "Real Wiimote, then turned off speaker data, and turned on continuous scanning
8. Put my dolphin bar into mode 4
9. Opened up skyward sword... no controls working
10. Pressed Alt-F5 and got a message
Wiimote 1 connected
Wiimote 1 disconnected
After playing around with it some more I found.
In mode 1 on the bar if i sync the wii remote it starts with only the player one light lit. Then shortly the player two light comes on aswell
Then if i switch to mode 2 the 1st, and the 4th light goes on
then in mode 3 it goes back to one.
Can anyone please help me? Is their a way to reset the dolphin bar and my wii remote?
Also is it possible to use the Wii remote as a gamecube controller as well?
I recently bought a mayflash thing. Here is what i did
1. Held sync
2. Plugged it in
3. Updated software
4. Press sync on bar and remote
5. The wii remote was controlling my mouse working just fine
6. Went into dolphin and went into wii controllers
7. Set remote one to "Real Wiimote, then turned off speaker data, and turned on continuous scanning
8. Put my dolphin bar into mode 4
9. Opened up skyward sword... no controls working
10. Pressed Alt-F5 and got a message
Wiimote 1 connected
Wiimote 1 disconnected
After playing around with it some more I found.
In mode 1 on the bar if i sync the wii remote it starts with only the player one light lit. Then shortly the player two light comes on aswell
Then if i switch to mode 2 the 1st, and the 4th light goes on
then in mode 3 it goes back to one.
Can anyone please help me? Is their a way to reset the dolphin bar and my wii remote?
Also is it possible to use the Wii remote as a gamecube controller as well?