Mac 4.0-5886 - 2 player syncs with 1 player

[koo]

Hello,

I have this adapter (http://www.amazon.com/Mayflash-GameCube-Controller-Adapter-nintendo-u/dp/B00RSXRLUE/ref=pd_sim_vg_2?ie=UTF8&refRID=1D99RQTQ9PDGW43CHENN)

1 player works perfectly fine, but when I add the 2 player controller it doesn't respond. I made two profiles and set both ports to Standard Controller. I was able to map out the 2nd profile with the second controller.

When I move the 1st player controller, the 2nd player onscreen responds while the 2nd player's controller doesn't work.

Any suggestions? I think it may be the adapter? I which the gc controllers and they both work if I use the 1st port. I tried 2, 3, 4 ports as well.

[JMC47]

I think this is an issue with their Mac drivers. You may want to email mayflash about it? If it is a problem on our end, I've never seen anything like this before though.

[koo]

(04-14-2015, 07:49 AM)JMC47 Wrote: I think this is an issue with their Mac drivers.  You may want to email mayflash about it?  If it is a problem on our end, I've never seen anything like this before though.

Gotcha, Thank you very much

[koo]

I found this on wiki "System level drivers are now available, but they require configuration through the GCpad as any other controller would." how would I do this?