Legend of Zelda Twilight Princess GAMECUBE

xraven13 · 06-15-2009, 05:43 PM #1

Hi..
Can anyone tell me what is best version of Dolphin to run Legend of Zelda Twilight Princess , GAMECUBE version...
I think that FPS is most important to me, i don't think that its playable on 25 FPS.. or i am wrong...
Is it possible to run it on 50 FPS and what PC configuration would be needed..
Thx in advance

**KHRZ** · 06-15-2009, 05:50 PM #2

Many games runs natively in 25/30 FPS (PAL). If you have PAL version, choose 60 mhz instead of 50 if possible. NTSC runs in 30 FPS only I think.

xraven13 · (This post was last modified: 06-15-2009, 06:03 PM by xraven13.)

I got NTSC version.. So, 30 FPS is enough to make everything fast enough so that it doesn't look slower then it should be , right..
I was thinking that eye needs 50 FPS at least.. .D

xraven13 · 06-15-2009, 07:47 PM #4

Okay, great...
Can anyone tell me what would be best SVN version of Dolphin to run Legend of Zelda TP GAMECUBE version...

**nosound97** · 06-15-2009, 07:52 PM #5

I think it works good even with latest revs

xraven13 · 06-15-2009, 09:00 PM #6

Well, i heard that after Wii support was added , some errors appeared... Did u played LOZ TP Gamecube version on Dolphin emulator..

jasong · 06-15-2009, 11:19 PM #7

Ok firstly you want to be running at 30fps because that is what the game was built to. Any faster is TOO fast - believe me there are some areas where it hits 40+fps and you need to throttle it.

Then basically the latest revs are always the fastest. If you have a 64 bit pc, use the 64-bit version, it is slightly faster. JITIL on 32 bit is faster than non-IL. There are some areas where it gets very slow like in Hyrule field - turning off EFB copy (by pressing E) helps to gain a bit of speed.

Iulius · 06-15-2009, 11:23 PM #8

(06-15-2009, 05:50 PM)KHRZ Wrote: Many games runs natively in 25/30 FPS (PAL). If you have PAL version, choose 60 mhz instead of 50 if possible. NTSC runs in 30 FPS only I think.

pal version only needs 25fps for full speed when choosing 50hz.

i dont see any reason for choosing 60hz unless your machine is godlike Tongue

bigroy · (This post was last modified: 08-25-2009, 04:34 AM by bigroy.)

I use 3950 - somewhere after that things went bad (for me at least)

The problem seems to be with dual core support - if I enable dual core TP grinds to an almost complete halt, if I disable dual core it goes a bit faster, but not as fast as 3950 with dual core enabled

I keep checking the new revs, but so far none of them have fixed this problem

My machine is dc e5200, 4gb, Geforce 9600GT

**nosound97** · 08-25-2009, 05:09 AM **#10**

Try using latest revisions