Ipega 9083 buttons X & Y are now both Y

05-27-2019, 08:22 AM #1

I'm not sure if this goes in here for Wind Waker or in the controller section

I bought an Ipega 9083 a couple months ago and everything was fine. However, now, for some reason button "X" has somehow remapped itself to button "Y." So, when I go to the settings to map the buttons, when I setup "Y" it says "PG-9083: Button 99, but when I go to map "X" it maps to 99 as well.

I've tried repairing, remapping, rebooting the phone, etc. Anyone else heard of this? Any ideas of things to try? The controller hasn't been dropped or through any other type of abuse.

Thanks in advance!

06-20-2019, 01:36 AM #2

I'm a little late, but I ran into a similar issue trying to configure a generic bluetooth controller. I had this issue for the wii classic controller, but I assume it's similar for the gamecube one as well. The only way I could find to fix it was to go into the file 'dolphin-emu/Config/Dolphin.ini' and manually edit the configuration.

There should be a few lines that look something like this:

InputX_0 = Device '<device id>' -Button 99
InputX_1 = Device '<device id>' -Button 99
InputY_0 = Device '<device id>' -Button 100
InputY_1 = Device '<device id>' -Button 100

Make sure that the button number at the end of the line for the 0 and 1 versions of each button are the same. InputX_0 should be the same as InputX_1, and likewise for InputY_0 and InputY_1.

Hope this helps