Help calibrating my xBox controller's triggers

12-22-2013, 01:50 AM #1

I know there have been several threads asking for help with this problem and I've seen a few, but none helped. My problem is that when I go to lightly press my L or R triggers, the emulator thinks I'm not pressing at all. Then, when I press a little harder, it thinks I'm pressing all the way. I believe this has something to do with the threshold and I've tried adjusting that but to no avail. If someone could help me fix this or provide a link to a thread that would help, I would really appreciate it. Thanks!

**Billiard26** · 12-22-2013, 10:27 PM #2

Show your config.
You will most likely want your right trigger mapped to both R and R-Analog. (and the same for the left) (searching the forum would probably reveal this)

12-23-2013, 12:18 AM #3

(12-22-2013, 10:27 PM)Billiard26 Wrote: Show your config.
You will most likely want your right trigger mapped to both R and R-Analog. (and the same for the left) (searching the forum would probably reveal this)

I searched and I did what they all said but nothing really worked. They all just said to lower the threshold.

[Image: hidK72y.png?1]

Soopah · 12-23-2013, 01:11 AM #4

actually you didn't set L-Analog and R-Analog so you have just L and R like a button.

12-23-2013, 01:19 AM #5

(12-23-2013, 01:11 AM)Soopah Wrote: actually you didn't set L-Analog and R-Analog so you have just L and R like a button.

I went off of a picture of a GameCube controller when I configured this. I didn't see anything labeled as L or R analog. I just used the back triggers. What am I supposed to set as the analog?

12-23-2013, 07:55 AM #6

I found the problem. I didn't know that the analog was also supposed to be set up with the triggers. This thread can be locked or deleted.