GeckoCodes cause game to start and stay at 0%....

[FlashBangGamer1]

Hello, I'm newer to this forum and I don't know if this is the right section to put this in, but I will say it anyways. I have recently been emulating wii games on the Dolphin Emulator. I have been using Punch Out!! (Wii), and I found out that there are these things called GeckoCodes. However, this is where the problem arose. Whenever I went and downloaded the codes and activated them, the game would start up but wouldn't show the wiimote screen and just stick at 0%. Am I doing something wrong here? There are pictures below which show my settings and the codes themselves. Please, I really want to solve this....

[ExtremeDude2]

Did you enable USBGekko in the memorycard slot? (do you even need to do that?)

[FlashBangGamer1]

(10-27-2015, 08:13 AM)ExtremeDude2 Wrote: Did you enable USBGekko in the memorycard slot? (do you even need to do that?)

I'm not sure. How do you even do that? I didn't know there was an option like that. Can you clarify what I have to do?

[ExtremeDude2]

It is under the GC section.

[FlashBangGamer1]

(10-27-2015, 09:06 AM)ExtremeDude2 Wrote: It is under the GC section.

So, is that all I do? I clicked it under memory Card B. Do I need to do anything else?

[ExtremeDude2]

Well you could always try it and find out

[KHg8m3r]

In the first tab of the Config menu, uncheck the Enable Cheats Box, and set the framelimit to Auto

[ExtremeDude2]

Why would he uncheck cheats?

[KHg8m3r]

The way he worded it sounds ambiguous to me if the game runs properly anymore even with the cheats turned off, so I was trying to double-check.

[FlashBangGamer1]

(10-28-2015, 03:24 AM)KHg8m3r Wrote: The way he worded it sounds ambiguous to me if the game runs properly anymore even with the cheats turned off, so I was trying to double-check.

It worked! I'm so happy X3