When I go into the Controller settings in Dolphin, I select Standard Controller, but when I go to configure the controller, Dolphin isn't recognizing it... my only choice is "keyboard". I'm using an official Nintendo GC Controller.
I am also using the YCCTEAM GameCube Controller Adapter for the Wii U/Switch/PC. I followed the instructions on the Dolphin wiki page and I installed the driver via Zadig (only the device showed up as "GameCube Controller Adapter", not "WUP-028"; and the USB ID showed up as "0079 1846", not "057E 0337"). If I toggle the switch to Wii U, then it does recognize the adapter as "WUP-028" with the correct USB ID. Problem is I want to use it with my PC, not with the Wii U.
I noticed a similar thread to this, but there were no answers, so I'm asking again in hopes someone knows what is wrong.
Any help would be greatly appreciated!!
Computer Specs:
Windows 11
Dolphin version 5.0
I am also using the YCCTEAM GameCube Controller Adapter for the Wii U/Switch/PC. I followed the instructions on the Dolphin wiki page and I installed the driver via Zadig (only the device showed up as "GameCube Controller Adapter", not "WUP-028"; and the USB ID showed up as "0079 1846", not "057E 0337"). If I toggle the switch to Wii U, then it does recognize the adapter as "WUP-028" with the correct USB ID. Problem is I want to use it with my PC, not with the Wii U.
I noticed a similar thread to this, but there were no answers, so I'm asking again in hopes someone knows what is wrong.
Any help would be greatly appreciated!!
Computer Specs:
Windows 11
Dolphin version 5.0