GameCube Adapter Issue

[not_langston]

I followed the instructions here to no avail. I'm using an official Nintendo brand GameCube Controller found here and a 3rd party GameCube to Wii U/Switch adapter found here. I use this adapter and controller on my Switch regularly, and have no issues on the Switch whatsoever. Tried using Zadig to update the drivers for the adapter, the USB ID was as it should be, 057E 0337, yet when I launch Dolphin to play Wind Waker, my controller isn't recognized. As soon as I launch Dolphin and go to Controllers, I hit Configure on GameCube Adapter for Wii U, and it reads, "Adapter Detected." No problems, right? But when I launch Wind Waker and check my controller config, it flickers between "Adapter Not Detected" and "Adapter Detected," and my controller doesn't function in Dolphin. I know there have been plenty of threads about this before but I couldn't find any that offered a solution that worked for me. Is there anything I can do besides buying a new GameCube Adapter? If that is the only solution, should I just buy the Mayflash one then? Sorry for making another thread on this I'm just at a loss, been trying to reminisce over some nostalgic Wind Waker for hours now. Thanks in advance.

[ExtremeDude2]

Known issue, no known solution afaik.

[not_langston]

(06-29-2019, 08:45 AM)ExtremeDude2 Wrote: Known issue, no known solution afaik.

So my best bet is to buy a new adapter? I tried deleting vJoy from my computer, now Dolphin crashes whenever I try to run a game  but that's not a big issue I can figure that out.