I was wondering if there is a way to force Dolphin to change what dinputs come in as from the USB ports?
I am using generic USB Gamecube controllers and when I have all 4 controller plugged in, the USB port that goes to my spot in the living room (its a full emulator rigg setup) registers as dinput 2. Now the problem here is that if I'm by myself and I only have my one controller plugged in, it comes in as dinput 0 which is currently set to player 3. Now first off, the reason I can't just switch USB ports is because then I'll cause 3 other emulators to have this issue. Secondly I could just plug in 3 more controllers everytime I start up Dolphin, but I'm here hoping to avoid that as it kinda hurts the whole "startup and go" experience.
So essentially what I'm asking is if there is a way to force Dolphin to register "my USB port" as dinput0 instead of dinput2? Or is there a way to "trick" Dolphin into thinking all 4 controller are connected when they are not physically connected?
I am using generic USB Gamecube controllers and when I have all 4 controller plugged in, the USB port that goes to my spot in the living room (its a full emulator rigg setup) registers as dinput 2. Now the problem here is that if I'm by myself and I only have my one controller plugged in, it comes in as dinput 0 which is currently set to player 3. Now first off, the reason I can't just switch USB ports is because then I'll cause 3 other emulators to have this issue. Secondly I could just plug in 3 more controllers everytime I start up Dolphin, but I'm here hoping to avoid that as it kinda hurts the whole "startup and go" experience.
So essentially what I'm asking is if there is a way to force Dolphin to register "my USB port" as dinput0 instead of dinput2? Or is there a way to "trick" Dolphin into thinking all 4 controller are connected when they are not physically connected?