Dolphin Gamecube controller Mayflash doesn't work

conceptual · 03-23-2014, 12:13 AM #1

I recently got the Mayflash gamecube adapter, I plugged it in my computer and in the devices and printers it works perfectly, all the button inputs are registered. But when I go to Dolphin emulator and click on "GCPad" my whole computer starts lagging and dolphin recognizes "USB GamePad" but it doesnt recognize any buttons, anyone got any suggestions?

http://puu.sh/7F0UR.png

conceptual · 03-23-2014, 01:45 AM #2

Anyone?

**JMC47** · (This post was last modified: 03-23-2014, 01:50 AM by JMC47.)

did you try actually configuring the buttons?

Also make sure you have the controller plugged into the proper side of the Mayflash. I use one as well, so i know it works.

conceptual · 03-23-2014, 02:04 AM #4

(03-23-2014, 01:49 AM)JMC47 Wrote: did you try actually configuring the buttons?

Also make sure you have the controller plugged into the proper side of the Mayflash. I use one as well, so i know it works.

Yes, it works for like 5 seconds, and then it starts lagging, after the 5 seconds, when I start a game up, my audio starts lagging and my button inputs dont work anymore

**JMC47** · 03-23-2014, 02:34 AM #5

It sounds like your controller is disconnecting or something; likely a problem with your hardware rather than dolphin. You could try installing the mayflash drivers or using xinput/dinput instead.

conceptual · 03-23-2014, 05:27 AM #6

(03-23-2014, 02:34 AM)JMC47 Wrote: It sounds like your controller is disconnecting or something; likely a problem with your hardware rather than dolphin. You could try installing the mayflash drivers or using xinput/dinput instead.

It works when I disconnect and reconnect the mayflash usb cable while my game is running, apparantly.