Difficulty mapping controller in Dolphin

Leatty · (This post was last modified: 01-21-2014, 06:52 AM by Leatty.)

I'm using a gamecube controller and have mapped everything successfully except for the L and R analogs, which are needed to "lightly push" the L and R buttons. When trying to map them, they are incredibly oversensitive. Just barely tapping the L/R buttons maxes them out to 99 threshold. There's no "sliding" at all; the moment I even accidentally nudge the button it maxes out. How do I fix this?

**Billiard26** · 01-21-2014, 04:37 PM #2

Show a screenshot of your gcpad config..

Leatty · 01-21-2014, 09:34 PM #3

(01-21-2014, 04:37 PM)Billiard26 Wrote: Show a screenshot of your gcpad config..

This is me barely touching the R-button.

**ulao** · 01-21-2014, 10:49 PM #4

Is this a may flash device? If so try the latest drivers on their main page as this was a known bug for there adapter.

Leatty · 01-21-2014, 11:23 PM #5

(01-21-2014, 10:49 PM)ulao Wrote: Is this a may flash device? If so try the latest drivers on their main page as this was a known bug for there adapter.

Totalconsole

**ulao** · 01-22-2014, 01:39 AM #6

Then check the response in windows itself. Windows has a game controller test app in the control panel. See if the range is good in there. If it is, I'm not sure what to thing. If its not, calibrate it.

**Billiard26** · 01-22-2014, 07:15 AM #7

Also, unrelated, your C-Stick left aught to be ZR- not ZR+-.

Leatty · (This post was last modified: 01-22-2014, 07:48 AM by Leatty.)

(01-21-2014, 10:49 PM)ulao Wrote: Is this a may flash device? If so try the latest drivers on their main page as this was a known bug for there adapter.

It actually is a mayflash despite ordering from totalconsole. i downloaded their driver from may 2013 (most recent on their downloads page) and installed it, but it didn't do anything. how do i change drivers for dolphin?

**ulao** · (This post was last modified: 01-22-2014, 08:24 AM by ulao.)

There was also a firmware fix for mayflash for the L/R buttons. This you need to contact them for. I dont think you have the issue but I would start with them. If you answer my control panel advice I'll know if its a problem with dolphin or the driver.

this make no sense --> how do i change drivers for dolphin?

Drive are for the OS not dolphin. Dolphin uses direct X or SDL.

Leatty · 01-22-2014, 09:30 AM **#10**

(01-22-2014, 08:22 AM)ulao Wrote: There was also a firmware fix for mayflash for the L/R buttons. This you need to contact them for. I dont think you have the issue but I would start with them. If you answer my control panel advice I'll know if its a problem with dolphin or the driver.

this make no sense --> how do i change drivers for dolphin?

Drive are for the OS not dolphin. Dolphin uses direct X or SDL.

i guess it's not a problem with dolphin...

the "set up USB controller" interface was actually different prior to installing the newer Mayflash driver, and didn't have calibration for the L and R analogs I believe.

however, i can't find any way to calibrate the L and R analogs here despite it showing them.