In the meantime I built myself a receiver based on a real Wii BT module (J27H002, see https://forums.dolphin-emu.org/Thread-ho...#pid495793), but unfortunately the problem remains: it is not sufficient to press 1+2.
When I press 1+2 it tells me that Wiimote 1 was found and connected (in the upper left corner or the log window) and the Wiimote LEDs stop blinking, but all 4 are dark afterwards and some seconds later it tells me that Wiimote 1 was disconnected again.
When I press Sync Dolphin tells me that a Wiimote was found and connected and LED 1 is on afterwards. In this state it doesn't disconnect after some seconds and everything works fine.
No I haven't. How can I try that?
When I press 1+2 it tells me that Wiimote 1 was found and connected (in the upper left corner or the log window) and the Wiimote LEDs stop blinking, but all 4 are dark afterwards and some seconds later it tells me that Wiimote 1 was disconnected again.
When I press Sync Dolphin tells me that a Wiimote was found and connected and LED 1 is on afterwards. In this state it doesn't disconnect after some seconds and everything works fine.
(07-01-2019, 05:06 AM)mbc07 Wrote: Have you tried the old "emulate a BT Adapter" mode from Dolphin? It'll work only with genuine Wiimotes and you might experience a little more lag than BT Passtrough mode, but it should work with any BT Adapter supporting at least version 2.0 of the technology. There's also the issue with Wiimote audio which is broken for non-TR models but that should not affect you as all your Wiimotes are -TR...
No I haven't. How can I try that?