Cannot manually configure controls while using 8BitDo SN30 Pro+ in XInput mode

[voorhees_13]

I am trying to manually set controls for Dolphin using an 8BitDo SN30 Pro+ in XInput mode via USB. I cannot change any control (the only controls that actually respond are A, X, and the triggers) and when I try to move the left stick up or down to register, it will only register left or right motions. The C-Stick (right stick) will not input at all. Dolphin works perfectly fine with an Xbox One controller being used in USB mode, so I don't know what gives trying to use the 8BitDo.

[JosJuice]

If you are using Dolphin 5.0 stable, update to a development version. There have been fixes for mapping certain XInput controllers.

[voorhees_13]

(01-14-2020, 08:19 PM)JosJuice Wrote: If you are using Dolphin 5.0 stable, update to a development version. There have been fixes for mapping certain XInput controllers.

That worked, thanks! :]